Window Regilators

[John in VA]

#6 - White ones around the perimeter of the panel.
https://www.realoem.com/bmw/enUS/sho...diagId=51_3729

[Fried_Chicken]

I just bought a whole bunch of window regulators off eBay for like $20/each. One was broken before installed, but the rest are working well.
Buying from FCP with their lifetime shit is probably not a bad idea.

The clips you can get at the BMW dealership, they're like $1 each. I just did the speaker in my passenger side door and needed 5 of them. I got an additional 15 from the dealership on the way. So far I see no reason to think the bavsound speaker kit is any better than stock, but it's cheaper than replacing all the stock speakers ��*♂️

[das boots]

Just placed my order with clips. Off to HD later for the 3M Butyl sealant tape.

[das boots]

Went to HD try to locate this Butyl caulk strips. They do not carry those or whatever is closest. All they have are weatherstrips for home windows or for the A/C.

Where do I get those pliable butyl caulking strips? Amazon has some but unfortunately, not familiar what they are selling. I am leaning towards the second item below.

https://www.amazon.com/Sealant-PROMO...1zcF9hdGY&th=1


https://www.amazon.com/Butyl-Sealant...zcF9tdGY&psc=1

Also do I have to replace the vapor barrier/liner? Where do I get those? RealOEM does not show any liner.


Thanks.

[John in VA]

Home Depot has this - it will probably work:
https://www.homedepot.com/p/Gibralta...9415/205945574

The Amazon link you provided is similar to what I have used. Advance Auto, Autozone, NAPA, etc., sell it in a roll for window installation. 3M Windo-Weld ribbon sealer 08612

If your vapor barriers are not torn/ripped up you can reuse them.
#12 Water/Sound Door Insulator Shield - Front Left - BMW (51-48-7-114-713); Front right - (51-48-7-114-714)
#9 Sound insulating door rear left: 51-48-8-196-127; Sound insulating door rear right: 51-48-8-196-128

https://www.realoem.com/bmw/enUS/par...0i&mg=51&sg=70

https://www.e46fanatics.com/threads/...r-diy.1169049/
https://www.youtube.com/watch?v=zOdp...TheNewMechanic

[das boots]

Home Depot has this - it will probably work:
https://www.homedepot.com/p/Gibralta...9415/205945574

The Amazon link you provided is similar to what I have used. Advance Auto, Autozone, NAPA, etc., sell it in a roll for window installation. 3M Windo-Weld ribbon sealer 08612

If your vapor barriers are not torn/ripped up you can reuse them.
#12 Water/Sound Door Insulator Shield - Front Left - BMW (51-48-7-114-713); Front right - (51-48-7-114-714)
#9 Sound insulating door rear left: 51-48-8-196-127; Sound insulating door rear right: 51-48-8-196-128

https://www.realoem.com/bmw/enUS/par...0i&mg=51&sg=70

https://www.e46fanatics.com/threads/...r-diy.1169049/
https://www.youtube.com/watch?v=zOdp...TheNewMechanic

Thanks. Orders already placed for the regulators and clips. Have to be very careful removing the vapor barriers.

[John in VA]

Thanks. Orders already placed for the regulators and clips. Have to be very careful removing the vapor barriers.

I loosen/remove the top & side sections, trying to leave the best seal possible at the bottom as that is where the water comes in to flood the carpet! Chances are that someone has already been in the door in the past 20 years - if so, don't worry about it as you'll have a chance to seal everything well.

Use a heat gun to soften the caulk before using a razor blade to release the vapor barrier. When reattaching, heat the butyl up before pressing the barrier back into place.

[das boots]

I loosen/remove the top & side sections, trying to leave the best seal possible at the bottom as that is where the water comes in to flood the carpet! Chances are that someone has already been in the door in the past 20 years - if so, don't worry about it as you'll have a chance to seal everything well.

Use a heat gun to soften the caulk before using a razor blade to release the vapor barrier. When reattaching, heat the butyl up before pressing the barrier back into place.

Nobody has opened up the door panels. First time to have window regulators problem. Surprised it lasted this long. Thanks for heads up. Start from top and work to bottom. Preparation is the key.