Tony's ZHP Project

[Tnhl1989]

Hi everyone so pretty much I already started ordering parts and planning out a set of mods I will be doing to the ZHP. As for now I'll upload a before photo of the car and as time goes I'll upload more photos of the mods I will be doing. Just wait and see

VIN WBAEV53483KM04057



Mods already done -
Coded LCM - removed the tamper dot when I first purchased the car
AFE Intake - removed for BMW performance intake
Smoke Rear Corners - removed for OEM clears
Relocation Kit added (still pondering what to do instead; returned enco unit)
Retrofitted Lumbar Support into Front Seats
Valve Cover Replacement + VCG + Vanos Seals + Vanos Gasket
Clean ICV + DISA + TB + Intake Check Up
Replace ICC with Cold Weather ICC
F10 M5 Knob with Alcantara Shift Knob
Repair Silver Cube Trim
<strike>GOMINIGO 'NO HOLES' LPB Kit 01/22/2013</strike>
CCV, oil filter housing gasket, vcg, spark plugs, vanos swap, intake boots changed, icv grommet and vanos line 02/11/2013
LED License Plate + Lens
<strike>Aspherical Blind Spot Mirror 04/18/2013</strike>
M5 Fog Lights from ebay 05/08/2013
Clear lens all around 05/14/2013
M3 Switch Panel with TPMS wired to DSC 05/28/2013
PA Soft Speedo and Temperature Correction 03/02/2014
USMillworks Front Bracket with Quick Disconnect 03/02/2014
BMW Performance Strut Bar 03/17/2014
Corsa TSE3 exhaust 10/22/14
Carbon fiber emblems
Armrest delete center console and euro tray

To be added
BC Coilovers
SSK not sure what kind or just fix the oem one
Pulleys
Shark Injectors
Sprint booster with mod
Complete audio system overhaul
Cobywheel Rewrap
Refinish rims (135s, Beyern Mesh, 68s)
New front bumper and splitters + complete paint job
Hidden V1 in mirror plus update the V1
Fix driver side bolster and install side bolsters
M3 brake kit upgrade
Umnitza halo kit
LSD 3.46/3.37 ratio
Supercharger (not in the near future)
One side cup holder driver side

Maintenance -
112xxx CCV, oil filter housing gasket, vcg, spark plugs, vanos swap, intake boots changed, icv grommet and vanos line 02/11/2013
113140 Sway bar bushing - 04/04/2013
113490 oil change, replace oil drain plug - 04/25/2013
Fuel Filter 05/19/2013
Fuel Pump 05/19/2013
Rear Cushion Thanks to Joop 05/18/2013
Headlight housings 05/18/2013
Painted rear diffuser 06/02/2013
121865 Rear tires (hankook ventus v12 and bereyn mesh rims) 9/26/2013 -Thanks CHARLIE for the RIMS!
124500 Front tie rods 11/9/2013
124530 Transmission Fluid, Differential Fluid and BMW Performance Short Shifter 11/10/2013
133180 Guibo and oil change 4/20/14

///M Front End (Control arms, tie rods, spindles, brakes) 5/6/14

Added M3 Track mode
Added OEM Tirepressure RDKS RDC
Replacement aftermarket aspherical mirrors 5/7/14
New windshield and AL headlights 5/19/14
139848 LCM 4.5 10/2/14
139853 M3 Mirrors fixed and installed 10/4/14
141265 Corsa TSE3 Exhaust 10/22/14
14XXXX Rear Sun Shade 12/22/14
Reinforcement Plates M3 Rear End 5/31/15
Replace Lower control arms turner 6/22/15
152000 Oil Change7/13/15
186500 Clutch replacement
187000 BC Coils and Brake Pads/Rotors 11/14/18
188000 Installed Eonon GA9150KW 11/26/18
192500 Oil Change with liquid moly 5W-40 from FCP Euro 192500 5/1/2019
192500 Changed Pre-Cat oxygen sensors 5/1/2019
207800 Spark plugs NGK 3199 BKR6EQUP 5/18/2020
Miles 212749 9/19/22

Oil Change
Upper Coolant Hose
Lower Coolant Hose
Thermostat
Water Pump
Expansion Tank
Radiator Drain Plug

First got the car back and registered.


Most recent photo



M3 front end

[Pip]

Silver gray is taking over! Looking forward to the mods.

[derbo]

awesome! can't wait to see whats in store for this car. :D

[(BMW)]

Hope you have seat warmers, looks a little chilly there.

[Oli77]

Teaser thread! I already think the car is gorgeous as is.

[Tnhl1989]

Teaser currently. I will have some photos and stuff up once I get a chance to stop tearing apart the old 330xi.

@Rby - There are seat warmers. That was one of the options I must have. I didn't want to attempt that retrofit. However lumbar support didn't seem too hard though.

[danewilson77]

Good to see this get rolling.

[cakM3]

Tony,

Get the front license plate delete strip and gominigo tow hook license plate mount. It will look so much better! Can't wait to see your car in person

[Tnhl1989]

Already ahead of you on that mod Charlie. I forgot to add that to the list. I'm waiting for the mount to come in now.

[cakM3]

going to look awesome Tony! Now all you need is a good detail!