Sagging Bumper (Broken Brackets)

[328ioc]

Can any one suggest a good epoxy for a bumper repair?

I have a little bit of sag on my drivers side and i know for a fact one of the mounting point on the bumper appears to be broken.

Instead of buying a new bumper cover I would like to see If I can remedy the situation with glue/epoxy first.

[zj96sc]

Duramix 4040 is probably the "right" product to use, but you'll need to figure out a way to dispense the two part tube since their gun is another $50. I've just skipped their mixing tip and pushed the plungers down with a screwdriver and mixed it on my own.....but:

Honestly I'd be just fine using JB weld. Make sure you rough up contact areas with some 80 grit for a good key and just slather it on. Stuff is bulletproof.

[328ioc]

Thanks,

I was thinking JB would be the best call but i also saw that Bondo makes some stuff so I figured I would get opinions.