Wheel Studs

[M0nk3y]

Anyone have these installed and can give me insight?

Bimmerworld, Turner, Vorshlag, TCK all have their variants of the studs...just don't know who I should go with (Probably bimmerworld or vorshlag for money reasons).

I figured it would make my life easy when it comes to swapping wheels every weekend basically...and I think they look awesome.

Opinions?

[HokieZHP]

I don't but I've looked into them before. Will be getting some when I get new wheels. Vorshlag and Turner seem to be the most popular. No firsthand experience, just what I've seen.

[GMATT]

I did a DIY on the TMS studs I installed. I went with Turner purley because of their reputation on and off the track.

Gary

[brettbimmer]

I did a DIY on the TMS studs I installed. I went with Turner purley because of their reputation on and off the track.

Gary

They looked great on your ZHP at SIGfest Gary!!

[Mike V]

I run a set from BimmerWorld. They have a tendency to send the extra long ones though. Unless you're planning to run huge spacers, tell them you don't want the huge ones. They'll stick out quite a bit and you'd need a deep well socket to get them on and off. 75mm are the smaller ones. http://store.bimmerworld.com/standard-bulletnose-wheel-stud-p1352.aspx

[danewilson77]

I run a set from BimmerWorld. They have a tendency to send the extra long ones though. Unless you're planning to run huge spacers, tell them you don't want the huge ones. They'll stick out quite a bit and you'd need a deep well socket to get them on and off. 75mm are the smaller ones. http://store.bimmerworld.com/standard-bulletnose-wheel-stud-p1352.aspx

So the 75mm's can be used with up to a 12mm wheel spacer.

Sent from D.C.