Nivo
05-20-2011, 09:00 PM
Well I been thinking after strengthening the chassis mounting points I will have to address the rear end, axle shafts and axle stubs.
Components to get upgraded:
Driveshaft, custom aluminum
Axle stubs (something better then hollow parts)
Axle shafts (improved tripod/shaft)
treating the case and Ring and Pinion by the way of heat temper treating/WPC treating/Ion Nitriding/Cryo treating process. Not sure which one yet but I have all right in my city.
I will then install a wavetrac LSD.
Components to get upgraded:
Driveshaft, custom aluminum
Axle stubs (something better then hollow parts)
Axle shafts (improved tripod/shaft)
treating the case and Ring and Pinion by the way of heat temper treating/WPC treating/Ion Nitriding/Cryo treating process. Not sure which one yet but I have all right in my city.
I will then install a wavetrac LSD.