What else would I need to complete a manual swap?

[CarbonZHP]

Ive been offered a deal on the majority of a 5 speed swap. Since this is a new field for me and online DIYs are a little iffy on parts lists, I was hoping to get someone in here who has done the swap. What else would I need after this list to complete the swap? I know the pedal assembly and clutch master at least.

-5 speed manual transmission
-shifter linkage
-slave cylinder
-flywheel
-clutch (but you might want to buy a new one)
-most of the bolts (id have to look back through been a few months since I swapped)
-transmission support member
-throw out bearing and guibo
-driveshaft (but it is in 2 pieces and dies not have a CV joint, will need to buy one because I had to transfer it to the 6 speed drive shaft cause the one it had was busted)

[CarbonZHP]

So I need something like this to start http://www.ebay.com/itm/BMW-E46-323I-325I-328I-330I-M3-X3-FRONT-CLUTCH-BRAKE-LEVER-FOOT-PEDAL-PEDALS-OEM-/281897302799?hash=item41a2637b0f:g:utQAAOSwv-NWWZKG&vxp=mtr

[Johnmadd]

I think you need the wire that goes to the reverse lights.

[CarbonZHP]

Yeah Ill need to wire the clutch to the DME and EWS as well as reverse lights. Past the pedal assembly with both pedals, master cylinder, and then the clutch line to the trans, Im not sure what else Id need