18x9 et29 and 18x10 et40

[Indvdl M]

Thinking of a set with these specs.
235 or 245 in front and 255 or 265 in the rear. Calcs show rears should be ok, might need some fender massaging. Fronts seems a little more extreme. I don't want to go crazy with neg. camber but am currently at stock ride height. Anyone tried something near this? Thanks in advance.

[BCS_ZHP]

Running 19x8.5 et35 with 235/35 on front and 19x9.5 et45 with 265/30 on rear. No rub at stock height on stock suspension, no rub dumped to the bottom on PSS10 coilovers, absolutely no fender rolling required.

[Indvdl M]

Attached is my calc sheet. I will be moving the outer edge of the wheel outward 30mm-ish. The front will have no issues on the inside and I find it hard to beleive the rear does not have 9mm to spare on the inside. Doing some mearements on the car the rears should fit pretty easily assuming the proper tires size. The fronts might cause while turning. 15861

[BCS_ZHP]

Run your numbers on willtheyfit.com. It gives you a little visual chart showing the difference to the inside and out as compared to your current setup, then go out to the car and check those measurements.

[Indvdl M]

Did my PDF show up? It does a similar calc without the tire factor. I'll check it out. Thanks