Tools needed

[Au1994]

Ok, I ordered parts this weekend (thanks Ray) so pads and rotors all the way around are on the way.

I haven't done a brake job on the ZHP, or any other BMW for that matter. Are there any special tools or odd socket sizes I'll need?

Trying to avoid that 'Oh S#!$" moment when I'm part way in and am missing a tool.

[NoVAphotog]

Check out the guides from Pelican parts, for each one they usually have the "specs" of the job in the upper right table.

http://www.pelicanparts.com/BMW/techarticles/tech_main_e46.htm#brakes

[derbo]

Pads and Rotors is simple.

6mm Allen bit (would most likely prefer a Impact Hammer to prevent stripping this bolt)
7mm Allen bit
Flat head screwdriver
16mm and possible 14mm sockets.
Caliper Reset Tool (can use pliers plus old pads to reset the calipers)


you may want to do a brake flush too if you haven't done one in a few years.
-Brake fluid
-Brake Bleeder bottle (make one with tubing and a water bottle)
-9mm wrench
-10mm wrench (I don't rememeber what size the front bleeder is anymore)

[Au1994]

wow, thanks all. Based on this, I think I am covered!