Valve Cover Gasket replacement parts Q?

[pghZHP]

Hey everyone,

I'm finally getting around to replacing the VCG on my 04 330. As far as I know, it is still the original. I've had the car for over a year now and it's time to do the job.

I already have the oem VCG and the valve cover seal washers. I will also be changing the spark plugs while i'm in there. I am planning on doing this tomorrow and have set aside 5 hours as it's my first time doing this.

Are there any other parts I should have on hand? Should I stop by my BMW dealer and get some valve cover studs and washers? Whats the consensus on using sealant in a few areas?

I know this topic has been covered many times, but i'm just looking for some additional guidance.

Thanks!

[kayger12]

Shouldn't need any extra parts on hand. Just some RTV sealant for the half moons.

Just be careful not to over torque the bolts. Doesn't take much to snap them.

[ELCID86]

Some info here: http://www.zhpmafia.com/forums/showthread.php?5147-Vavle-Cover-Gasket-leaking

Good luck. Not that bad of a job. Just keep up with all the nuts, etc.

[pghZHP]

thanks guys.

[BCS_ZHP]

If you set aside 5 hours, how much beer can you consume over the last 4 hours?